Blog

LiFePO4 Battery in Bangladesh | SARBS

November 12, 2026 ยท 1 min read

SARBS supplies a 48V 100Ah LiFePO4 battery in Bangladesh for telecom sites that cycle, run hot and cannot carry lead-acid weight.

SARBS LiFePO4 battery for sites in Bangladesh

A LiFePO4 battery in Bangladesh has to live with heat, short grid hours and sites that rarely sit at a full charge. SARBS Communications Ltd. supplies a 48V 100Ah lithium iron phosphate battery for that duty, as a finished pack on the telecom DC bus.

What SARBS publishes about the chemistry

LiFePO4 is lithium iron phosphate. The SARBS product note compares it with lead-acid: up to ten times the cycle life, five times the float calendar life, about forty percent of the weight, and about twice the power at a high discharge rate, while keeping a high energy capacity. It is presented as a drop-in replacement. The same note says the chemistry reduces the risk of explosion or combustion from high impact, over-charging or a short circuit, and that the battery supports an unstable partial state of charge.

Partial state of charge is the ordinary day on a hybrid tower. The battery charges when the grid or the sun is there and discharges when it is not. A chemistry that tolerates that pattern is the reason SARBS pairs LiFePO4 with telecom sites and with solar hybrid plants, not only with a showroom display.

Where this battery is used

  • Telecom cabinets and tower DC plants, beside a rectifier that delivers 54V DC.
  • Sites that cycle daily and would otherwise replace lead-acid early.
  • Rooftops and compounds where the lift weight matters.

The longer cost comparison is in LiFePO4 versus lead-acid. Order from the product list or the contact page.

Figures and product notes on this page are taken from the public SARBS website, the SARBS LinkedIn page and the SARBS YouTube channel.

Categories: LiFePO4 Batteries, SARBS LiFePO4, SARBS Lithium Batteries

Tags: Bangladesh, LiFePO4, SARBS, SARBS LiFePO4